One thing you need to keep in mind if you own a pool is its cleanliness. Be it above-ground or in-ground; there is a need to own a vacuum system that gives you a thorough cleaning process.
Irrespective of different preferences in a vacuum system, it goes down to either having an automatic cleaning device or a manual device that keeps your pool clean regularly. Also, remember that your surface filter can only remove large particles of debris. The molecular debris can only be removed by a vacuum cleaner that runs along the bottom of the pool.
Here in this article, we will be discussing how to vacuum your above ground pool using a robotic vacuum device with a dual-stage basket and cartridge filtering system. This is more efficient among every other cleaning device, and it automatically runs on the surface of your pool for a thorough cleaning.
Step 1: Check the Water Level
Prior to vacuuming your pool, you need to make sure the water level in your pool reaches the level where you have your skimmer. The density of the water is a determinant of the performance of your vacuum cleaner. If the water density is low, it will reduce the pressure drawn by the device in sucking debris. Also, remember to clean your skimmer basket before commencing any vacuuming process.
Step 2: Make Sure there is Enough Hose to Reach Round the Pool
You do not want to encounter a situation where your hose runs short. Get this checked out before kickstarting your vacuum device. To do this, you need to position your vacuum cleaner by the edge of your pool. Do not make too close to the filtering system. Attach your hose and make sure it goes through up to the skimmer basket.
Step 3: Submerge the Vacuum Device in the Water
For your vacuum cleaner to work effectively, you need to make sure there are no air bubbles in the hose. Put your hose in the water to remove every air bubble and submerge the vacuum device in the water as well.
Step 4: Make All Necessary Connection to the Adapter Ports Provided
Here is where you need more of the manufacturer’s manual to get all necessary fitting plugged to the adapter. Make all connections as specified by the manufacturer into the suction port of the skimmer. The position of suction ports could vary depending on the model and manufacturer of your pool.
Some suction ports are found a little bit underneath the pool, positioned near the middle of the pool. Others are located inside the skimmer canister at the pool deck. Check the configuration manual on how to attach the elbow fitting to the suction port in the skimmer. In any way your configuration comes, it is always designed to allow the vacuum hose to be supplied from the flapper door.
Step 5: Switch on the Filtering System and Monitor Closely the Vacuum Unit and the Pump System
Your pool pump needs to be on while the vacuum cleaner is working. Regularly check the rotation speed of the wheels beneath the vacuum device. For the optimal performance unit, you can tweak the pump system. The greater the water flow, the faster the wheel rotates. Be careful not to over adjust or under-adjust the pump systems because it can result in poor performance or damage to your vacuum system.
Once you are done cleaning, removing the vacuum system from the water and clean it for storage.
Leave a Reply